Systems and software engineering - Life cycle profiles for very small entities (VSEs) - Part 5-2-1: Organizational management guidelines
2025-11-13
ISO/IEC 18047-6:2025
Information technology - Radio frequency identification device conformance test methods - Part 6: Test methods for air interface communications at 860 MHz to 930 MHz
2025-11-13
ISO 6080:2024/Amd 1:2025
Tobacco heating systems — Vocabulary — Amendment 1
2025-11-13
ISO 19599:2025
Operating procedures of chicken slaughtering
2025-11-13
ISO 7819:2025
Lithium — Vocabulary
2025-11-13
ISO 15105-2:2025
Plastics film and sheeting — Determination of gas-transmission rate — Part 2: Equal-pressure method
2025-11-13
ISO/IEC 29110-5-2-1:2025
Systems and software engineering — Life cycle profiles for very small entities (VSEs) — Part 5-2-1: Organizational management guidelines
2025-11-13
ISO 21755-3:2025
Motorcycles — Measurement method for evaporative emissions — Part 3: VT-SHED test procedure
2025-11-13
ISO/IEC 18047-6:2025
Information technology — Radio frequency identification device conformance test methods — Part 6: Test methods for air interface communications at 860 MHz to 930 MHz
2025-11-13
ISO 18777-2:2025
Transportable liquid oxygen systems for medical use — Part 2: Particular requirements for portable units
2025-11-13
ISO 19654:2025
Sludge recovery, recycling, treatment and disposal — Laboratory chemical conditioning procedure
2025-11-13
ISO 20760-2:2025
Water reuse in urban areas — Guidelines for centralized water reuse system — Part 2: Management of a centralized water reuse system
2025-11-13
ISO 20760-1:2025
Water reuse in urban areas — Guidelines for centralized water reuse system — Part 1: Design principle of a centralized water reuse system
2025-11-13
ISO/TS 4452:2025
Specification and demonstration of system reliability of single-use drug delivery systems
2025-11-13
ISO 11970:2025
Specification and qualification of welding procedures for production welding of steel and nickel-base castings
2025-11-13
IEC 60153-2:2025
Hollow metallic waveguides - Part 2: Relevant specifications for ordinary rectangular waveguides
2025-11-12
IEC 60153-2:2025
Hollow metallic waveguides - Part 2: Relevant specifications for ordinary rectangular waveguides
2025-11-12
IEC 60153-2:2025
Hollow metallic waveguides - Part 2: Relevant specifications for ordinary rectangular waveguides
2025-11-12
IEC 62899-302-7:2025
Printed electronics - Part 302-7: Equipment - Inkjet - Measurement methods of dot placement evaluation for printed electronics
2025-11-12
ISO 24835-2:2025
Natural gas upstream area — Determination and calculation of shale brittleness index — Part 2: Determination of shale mechanical characteristics based on triaxial testing method
