- 标准号
- 标准名称
- 发布日期
- ISO 5829:1984
- Resistance spot welding — Electrode adaptors, female taper 1 : 10
- 1984-08-31
- ISO 7461:1984
- Shipbuilding — Shiplines — Numerical representation of elements of the hull geometry
- 1984-08-31
- ISO 5019-5:1984
- Refractory bricks — Dimensions — Part 5: Skewbacks
- 1984-08-31
- ISO 6633:1984
- Fruits, vegetables and derived products — Determination of lead content — Flameless atomic absorption spectrometric method
- 1984-08-31
- ISO 5123:1984
- Documentation — Headers for microfiche of monographs and serials
- 1984-07-31
- ISO 4198:1984
- Surface active agents — Detergents for hand dishwashing — Guide for comparative testing of performance
- 1984-07-31
- ISO 3993:1984
- Liquefied petroleum gas and light hydrocarbons — Determination of density or relative density — Pressure hydrometer method
- 1984-07-31
- ISO 6703-1:1984
- Water quality — Determination of cyanide — Part 1: Determination of total cyanide
- 1984-07-31
- ISO 8152:1984
- Earth-moving machinery — Operation and maintenance — Training of mechanics
- 1984-07-31
- ISO 6703-2:1984
- Water quality — Determination of cyanide — Part 2: Determination of easily liberatable cyanide
- 1984-07-31
- ISO 6703-3:1984
- Water quality — Determination of cyanide — Part 3: Determination of cyanogen chloride
- 1984-07-31
- ISO 2256:1984
- Dried mint (spearmint) (Mentha spicata Linnaeus syn. Mentha viridis Linnaeus) — Specification
- 1984-07-31
- ISO 3645:1984
- Cinematography — Image area produced by 8 mm Type S motion-picture camera aperture and maximum projectable image area — Positions and dimensions
- 1984-07-31
- ISO 6897:1984
- Guidelines for the evaluation of the response of occupants of fixed structures, especially buildings and off-shore structures, to low-frequency horizontal motion (0,063 to 1 Hz)
- 1984-07-31
- ISO 5690-2:1984
- Equipment for distributing fertilizers — Test methods — Part 2: Fertilizer distributors in lines
- 1984-06-30
- ISO 2857:1973/Amd 1:1984
- Ground thread taps for ISO metric threads of tolerances 4H to 8H and 4G to 6G coarse and fine pitches — Manufacturing tolerances on the threaded portion — Amendment 1
- 1984-06-30
- ISO 3952-4:1984
- Kinematic diagrams — Graphical symbols
- 1984-06-30
- ISO 6749:1984
- Earth-moving machinery — Preservation and storage
- 1984-06-30
- ISO 1151-6:1982/Amd 1:1984
- Terms and symbols for flight dynamics — Part 6: Aircraft geometry — Amendment 1
- 1984-06-30
- ISO 7268:1983/Amd 1:1984
- Pipe components — Definition of nominal pressure — Amendment 1
- 1984-06-30

资质认证